New York City tap water for aquariums
New York City tap water can go in an aquarium once it is treated to remove chlorine. Its hardness (dissolved calcium and magnesium, in ppm, the same as mg/L on water reports) is usually soft (average 32 ppm; 18–100 ppm through the year), which suits 7 of the 24 fish and invertebrates we have hardness ranges for, including bettas, kuhli loaches and neon tetras, but it is softer than fancy goldfish, guppies, amano shrimp, mollies, platies and nerite snails need. Its pH is about 7.3.
Edited by Marin Hale · Numbers from NYC DEP’s own reports (2025 data), quoted below · Research is AI-assisted
New York City tap water at a glance
| Disinfectant | Chlorine |
|---|---|
| Hardness (GH) | Average 32 ppm (soft); 18–100 ppm through the year, about 1–6 dGH |
| Alkalinity (KH) how well the water holds its pH steady | 16–72 ppm; average 25 ppm |
| pH | About 7.3 (6.9–8.1 measured across the year; the figure is the average) |
| Where it comes from | Upstate reservoirs: the Delaware (50%), Catskill (almost 40%) and Croton (about 10%) systems |
| Utility and year | New York City 2025 Drinking Water Supply and Quality Report |
ppm is the same as mg/L, the unit most water reports use. 1 dGH (the unit aquarium test kits often use) is about 17.9 ppm. Bands from the US Geological Survey: soft up to 60 ppm, moderately hard up to 120, hard up to 180, very hard above.
Is New York City tap water safe for fish?
Yes, once it is treated. NYC DEP disinfects with chlorine. Use a water conditioner every time you add tap water, including water changes. It is on the setup checklist.
Which fish suit New York City tap water?
Matched on hardness only, from each fish’s checked range against the 18–100 ppm NYC DEP reports. The tap pH (about 7.3) is inside the range our sources give for 20 of them.
Hardness suits it 7 fish. Its hardness range covers everything the utility delivers.
| Fish | Hardness range |
|---|---|
| Betta fish | 18–269 ppm |
| Cardinal tetra | 18–215 ppm |
| Chili rasbora | 18–179 ppm |
| Ember tetra | 18–215 ppm |
| Harlequin rasbora | 18–215 ppm |
| Kuhli loach | 0–143 ppm |
| Neon tetra | 18–197 ppm |
Usually too soft 11 fish. The yearly average is softer than its range; only the hardest New York City water reaches it.
| Fish | Hardness range |
|---|---|
| Angelfish | 54–269 ppm |
| Bristlenose pleco | 54–340 ppm |
| Bronze corydoras | 36–269 ppm |
| Celestial pearl danio | 90–269 ppm |
| Cherry shrimp | 72–143 ppm |
| Honey gourami | 54–269 ppm |
| Panda corydoras | 36–215 ppm |
| Pygmy corydoras | 36–215 ppm |
| Tiger barb | 90–269 ppm |
| White cloud minnow | 90–358 ppm |
| Zebra danio | 90–358 ppm |
Too soft 6 fish. Even the hardest New York City water is softer than its range.
| Fish | Hardness range |
|---|---|
| Amano shrimp | 107–251 ppm |
| Fancy goldfish | 143–322 ppm |
| Guppy | 161–358 ppm |
| Molly | 215–447 ppm |
| Platy | 179–358 ppm |
| Zebra nerite snail | 179–322 ppm |
Ranges are what our sources say each fish tolerates. Hardness is only one check: to see whether fish get along and fit your tank, use the stocking calculator.
What to do next
- Buy a water conditioner that handles chlorine and use it with every refill and water change.
- Cycle the tank before any fish go in: how to tell it’s ready.
- Pick fish from “Hardness suits it” above, then check the mix in the stocking calculator.
- Test GH and pH once the tank is running, especially for fish in a “usually” group.
Sources
(5 pages, every value quoted)
- nyc.gov/assets/dep/downloads/pdf/water/drinking-water/drinking-water-supply-qual
- aquariumscience.org/index.php/4-4-aquarium-ph
- usgs.gov/special-topics/water-science-school/science/hardness-water
- aquariadise.com/best-aquarium-test-kit/
- aquariumscience.org/index.php/4-5-water-hardness
| Value | What the source says |
|---|---|
| Disinfectant | nyc.gov: “The water is first treated with chlorine, a common disinfectant that kills germs and helps prevent bacteria from growing in water pipes” nyc.gov: “Chlorine Residual, Free (mg/L)” |
| Hardness | nyc.gov: “Hardness (mg/L CaCO3) - - 313 18 - 100 32” |
| Alkalinity (KH) | nyc.gov: “Alkalinity (mg/L CaCO3) - - 295 16-72 25” aquariumscience.org: “Alkalinity is the buffering capacity of a water body; a measure of the ability of the water body to neutralize acids and bases and thus maintain a fairly stable pH level” |
| pH | nyc.gov: “pH (pH units) 6.8 - 8.2 (10) - 13,029 6.9 - 8.1 7.3” nyc.gov: “Sodium hydroxide raises the pH of the water, which further reduces corrosion of household plumbing” |
| Where it comes from | nyc.gov: “In non-drought periods, the Croton system provides about 10% of the daily supply; the Catskill, almost 40%; and the Delaware, 50%” |
| High pH in aquariums | aquariumscience.org: “Aquarium pH’s above 8.5 are not recommended because a chemical found in the aquarium produced by fish called ammonia becomes very toxic and because the ammonia oxidation process (“cycling”) slows down” aquariumscience.org: “Most fish have a large tolerance range when it comes to pH” aquariumscience.org: “The hobbyist should not “chase” pH with chemicals” |
| Hardness bands and dGH | usgs.gov: “0 to 60 mg/L (milligrams per liter) as calcium carbonate is classified as soft; 61 to 120 mg/L as moderately hard; 121 to 180 mg/L as hard; and more than 180 mg/L as very hard” usgs.gov: “Hardness is caused by compounds of calcium and magnesium” aquariadise.com: “1 dGH is equivalent to 17.9 ppm” |