Austin tap water for aquariums
Austin tap water can go in an aquarium once it is treated to remove chloramine. Its hardness (dissolved calcium and magnesium, in ppm, the same as mg/L on water reports) is usually moderately hard (average 93 ppm; 70–126 ppm through the year), which suits 13 of the 24 fish and invertebrates we have hardness ranges for, including bettas, angelfish and kuhli loaches, but it is softer than fancy goldfish, guppies, mollies, platies and nerite snails need. Its pH is high: about 9.6–9.8.
Edited by Marin Hale · Numbers from Austin Water’s own reports (2025 data), quoted below · Research is AI-assisted
Austin tap water at a glance
| Disinfectant | Chloramine (letting water sit doesn’t remove it) |
|---|---|
| Hardness (GH) | Average 93 ppm (moderately hard); 70–126 ppm through the year, about 4–7 dGH |
| Alkalinity (KH) how well the water holds its pH steady | 53–88 ppm |
| pH | About 9.6–9.8 (quarterly averages at the three treatment plants, January–September) |
| Where it comes from | The Colorado River, drawn from Lake Travis and Lake Austin |
| Utility and year | Austin Water Annual Water Quality Report 2025 |
ppm is the same as mg/L, the unit most water reports use. 1 dGH (the unit aquarium test kits often use) is about 17.9 ppm. Bands from the US Geological Survey: soft up to 60 ppm, moderately hard up to 120, hard up to 180, very hard above.
Is Austin tap water safe for fish?
Yes, once it is treated. Austin Water disinfects with chloramine. Unlike plain chlorine, it does not go away if you let a bucket of water stand.
Use a water conditioner whose label says it handles chloramine, every time you add tap water, including water changes. It is on the setup checklist.
Which fish suit Austin tap water?
Matched on hardness only, from each fish’s checked range against the 70–126 ppm Austin Water reports. The tap pH (about 9.6–9.8) is above the range our sources give for all of them; most fish tolerate a wide pH range, so don’t adjust it with chemicals (more on pH).
Hardness suits it 13 fish. Its hardness range covers everything the utility delivers.
| Fish | Hardness range |
|---|---|
| Angelfish | 54–269 ppm |
| Betta fish | 18–269 ppm |
| Bristlenose pleco | 54–340 ppm |
| Bronze corydoras | 36–269 ppm |
| Cardinal tetra | 18–215 ppm |
| Chili rasbora | 18–179 ppm |
| Ember tetra | 18–215 ppm |
| Harlequin rasbora | 18–215 ppm |
| Honey gourami | 54–269 ppm |
| Kuhli loach | 0–143 ppm |
| Neon tetra | 18–197 ppm |
| Panda corydoras | 36–215 ppm |
| Pygmy corydoras | 36–215 ppm |
Hardness usually suits it 5 fish. The yearly average is inside its range; the softest Austin water is below it.
| Fish | Hardness range |
|---|---|
| Celestial pearl danio | 90–269 ppm |
| Cherry shrimp | 72–143 ppm |
| Tiger barb | 90–269 ppm |
| White cloud minnow | 90–358 ppm |
| Zebra danio | 90–358 ppm |
Usually too soft 1 fish. The yearly average is softer than its range; only the hardest Austin water reaches it.
| Fish | Hardness range |
|---|---|
| Amano shrimp | 107–251 ppm |
Too soft 5 fish. Even the hardest Austin water is softer than its range.
| Fish | Hardness range |
|---|---|
| Fancy goldfish | 143–322 ppm |
| Guppy | 161–358 ppm |
| Molly | 215–447 ppm |
| Platy | 179–358 ppm |
| Zebra nerite snail | 179–322 ppm |
Ranges are what our sources say each fish tolerates. Hardness is only one check: to see whether fish get along and fit your tank, use the stocking calculator.
Why Austin water has a high pH
Austin Water softens its water with lime, which also helps coat pipes and keep lead out of drinking water. Its water reads pH about 9.6–9.8 (quarterly averages at the three treatment plants, January–September).
That is above the pH range our sources give for every fish on this page; the highest any of them reaches is 8.5.
- Most fish have a large tolerance range when it comes to pH, according to Aquarium Science, and it advises against chasing pH with chemicals.
- It also advises against a tank pH above 8.5: ammonia from fish waste is more toxic and the bacteria that clear it work more slowly. So finish cycling the tank before any fish go in.
What to do next
- Buy a water conditioner that handles chloramine and use it with every refill and water change.
- Cycle the tank before any fish go in: how to tell it’s ready.
- Pick fish from “Hardness suits it” above, then check the mix in the stocking calculator.
- Test GH and pH once the tank is running, especially for fish in a “usually” group.
Sources
(8 pages, every value quoted)
- austin.widen.net/view/pdf/olm10prt8x/AW_WQR_Report_2025.pdf
- austin.widen.net/view/pdf/tfnrfvsdpa/WQS-2025-Q1.pdf
- austin.widen.net/view/pdf/fjhmngnq8x/WQS-Q2-2025.pdf
- austin.widen.net/view/pdf/zyamp0i9pv/WQS-2025.pdf
- aquariumscience.org/index.php/4-4-aquarium-ph
- usgs.gov/special-topics/water-science-school/science/hardness-water
- aquariadise.com/best-aquarium-test-kit/
- aquariumscience.org/index.php/4-5-water-hardness
| Value | What the source says |
|---|---|
| Disinfectant | austin.widen.net: “Yes, Austin Water uses chloramine to disinfect our drinking water” |
| Hardness | austin.widen.net: “Total Hardness (as CaCO3) (ppm) [gpg] Not Applicable 70 [4.1] 126 [7.4] 93 [5.4]” |
| Alkalinity (KH) | austin.widen.net: “Total Alkalinity (as CaCO3) 159 160 159 73 74 88” austin.widen.net: “Total Alkalinity (as CaCO3) 156 156 156 61 63 78” austin.widen.net: “Total Alkalinity (as CaCO3) 151 151 139 53 57 58” aquariumscience.org: “Alkalinity is the buffering capacity of a water body; a measure of the ability of the water body to neutralize acids and bases and thus maintain a fairly stable pH level” |
| pH | austin.widen.net: “pH (units) 8.25 8.25 8.17 9.66 9.72 9.59” austin.widen.net: “pH (units) 8.15 8.17 8.20 9.73 9.74 9.63” austin.widen.net: “pH (units) 8.07 8.09 7.89 9.75 9.78 9.66” austin.widen.net: “Austin Water’s lime softening process helps coat pipes and prevent corrosion that could leach lead into drinking water” |
| Where it comes from | austin.widen.net: “Austin Water draws surface water from the Lower Colorado River as it flows through Lake Travis and Lake Austin” |
| High pH in aquariums | aquariumscience.org: “Aquarium pH’s above 8.5 are not recommended because a chemical found in the aquarium produced by fish called ammonia becomes very toxic and because the ammonia oxidation process (“cycling”) slows down” aquariumscience.org: “Most fish have a large tolerance range when it comes to pH” aquariumscience.org: “The hobbyist should not “chase” pH with chemicals” |
| Hardness bands and dGH | usgs.gov: “0 to 60 mg/L (milligrams per liter) as calcium carbonate is classified as soft; 61 to 120 mg/L as moderately hard; 121 to 180 mg/L as hard; and more than 180 mg/L as very hard” usgs.gov: “Hardness is caused by compounds of calcium and magnesium” aquariadise.com: “1 dGH is equivalent to 17.9 ppm” |